Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Trade > Certificate for 8400 for a 6600
1 -
Re: VPN discussion on which type
Name of VPN (SoftEther, WireGuard, OpenVPN, TailScale, ZeroTier, Ubiquity, etc) ZeroTier Server (radio end) requirements (RPI, runs on a Router, etc) Runs on Most Routers or a Pi Client requires (run…1 -
Re: split mode will not transmit
It's one of the 3.3 + Features, Sometimes you can make it work by toggling between modes. This and the loss of persistence on RX antennas making the RX ports useless keeps us on 3.2.39 at the co…1 -
Re: SO2R: Antenna may not be changed while transmitting
Settings / Radio setup / TX tab, Set the TX Delay to 50ms and get everything working right. Then you can, if you want, decrease it to find where the issues begin and raise it a bit above that level. …2 -
Re: Workaround for antenna gain reset in 3.5.8
Alan, The way it is supposed to work, and did until 3.3 is... If you have RX A set @ +24 because you have a low gain RX antenna ANT1 (RX) set to +8 normally used on Yagi.... When you Swap between the…2
